Finishing the Elevator

Hours: 2.5

With most of the preparations out of the way and half of the skins riveted, I took one more session to finishing the Elevator.

There was only one extra part I had to do for 3 of the rivets that were on the bottom edge. In order for them to fit correctly, I had to shorten the rivets so they wouldn’t protrude out.
Rivet too long to fit Fitting rivet after I shortened it I mounted the rivet in my bench vise and filed it down to size Shortened Rivets on the right and one with normal length on the left

Aside from that, I just went to town and pulled the rest of the few hundred rivets.
Time to pull some rivets Halfway done riveting the skins Final set of rivets ready to be riveted Riveting the Trim Tab

The last part on the riveting side was the front lip.
Clecoing the front lip Riveting the front lip

One of the holes on the lip has to be enlarged to fit a grommet for the wiring for the Elevator Trim Tab. I enlarged the hole using my step drill bit and then installed a snap bushing.
Marked out the hole that needs to be enlarged for the wiring Marked out the size on the step drill bit Hole enlarged and Snap Bushing installed

The last part was to install the center balance counterweight. I did some test fitting with this, but the AN3-13A bolts that one of the versions of the manual that I have mentioned are too short, so I’ll check with the factory on the proper length.
Test fitting the Balance Counterweight - the bolts are too short

With that being said, the general assembly of the Elevator is completed:

Timelapse of the complete construction of the Elevator

With the Elevator construction completed, I’ve also finished my video timelapse of the process:

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.